| Thank you for
purchasing a BRITELYT product. This
precision handcrafted product has
been manufactured for BriteLyt.
With a little care, this stove will
serve you a lifetime. (You can even
will it to your heirs c'mon, they
deserve it.) VIDEO HOW TO PAGE STOVE ASSEMBLY: Stove Operating Instructions
1. Take stove out of box...
Stove comes pre-assembled.
2.
Look over stove and see that nothing
is missing, funnel included.
****DO
NOT LEAN DIRECTLY OVER STOVE(Emits
large preheater flame from part STV-226)*******
***LEAVE
FRAME ON STOVE, DURING LIGHTING
PROCESS)****
ALWAYS
REMEMBER -- SAFETY FIRST!!!!
-- LIGHT IT OUTDOORS
FAMILIARIZE
YOURSELF WITH ANY STOVE AND/OR
LAMP BEFORE OPERATING.
!! WASH OUT TANK (use water or Fuel) BEFORE USING !!
Look inside box. There may be loose parts & funnel inside(SEE PHOTO BELOW). Remove Stove from box (holding burner & frame, when lifting out of box).
(Check for loose parts - SEE ABOVE PHOTO)
Reinstall Part #13 (Bleeder Screw), onto #149 (Pressure Gauge). SEE ABOVE PHOTO
Install #STV-220 (Flame Tube w/holes). Snug tube, carefully. DO NOT PRESS & TWIST TOO HARD!! Aim tube, in direction shown in photos above & below.
If you
Preheat with alcohol use cup (tray) its on top of the burner see below (photo 10)
Photo 10 
Preheater Direction
* Remember to always use battery operated smoke detectors and carbon monoxide detectors in the home. It is prudent to protect yourself from any potential hazards of using ANY fuel burning appliance in your home. stoves should be use outside.
_______________________________________________________________________
Upkeep of lanterns and stoves:
1.Do
not store fuel in lantern or stove
for long periods of time.
2.
When using " Bio" fuels clean
out tank and jets by adding some
fuel cleaner (like carburetor
cleaner) with your fuel in the
lantern or stove. Use 4 caps full
of a carburetor cleaner to 12
oz's. to a tank.
2a.You
can also use a half of a tank
of Coleman-type or similar type
of fuel in the lantern or stove
tank.
3.
All other fuels except Coleman
type fuels - use carburetor cleaner
in the fuel (4 caps to a tank
full of fuel, every 10 fill ups
or less).
4.
Tighten up the # 50 always check
this part, when replacing a mantle,
make sure the part # 33 has not
dropped down close to the # 50.
Raise # 33 high as you can for
optimum performance. Most problems
with the lantern will be caused
by these two (2)....items # 50
and # 33.
5.
Preheater
Direction above photo:
Stove....Make sure you preheat
the area as shown in our stove
instruction page on this site,
and preheat long enough. (preheat
time approx: 50 sec. to 90 sec.)
6. ITSIE-BITSIE TID-BITS Minor maintenance
Stove Breakdown and Replacement Parts Price List
|
