BriteLyt Patented Stoves
Video demonstration Methanol Ethanol Stove
1. Take stove out of box... Stove is pre-assembled.
2. Look over stove and see that nothing is missing, funnel included.
****DO NOT LEAN DIRECTLY OVER STOVE(Emits large preheater flame)*******
***LEAVE FRAME ON STOVE, DURING LIGHTING PROCESS)****
ALWAYS REMEMBER -- SAFETY FIRST!!!! -- LIGHT IT OUTDOORS
FAMILIARIZE YOURSELF WITH ANY STOVE AND/OR LAMP BEFORE OPERATING.
!! WASH OUT TANK (use water or Fuel) BEFORE USING if needed!!
If you need to print this page use Landscape.
OPERATING DIRECTIONS: (CHECK FOR LEAKS FIRST!!! Fill stove & add pressure to detect any leaks)
(1) Fill the stove with Ethanol,Methanol or Alcohol... DO NOT OVERFILL. Remove Fuel Cap/with gauge. STV-149. Tighten the filler(STV-149 see photo below) and bleeder cap(# 13) (the rough feeling, round things), by turning clockwise. (To the right - part STV-149... same as lantern part#149). See photo below 1. Make sure you put frame back on stove before using: DO NOT Attach frame, WHILE STOVE IS IN OPERATION..
(2) MAKE SURE KNOB IS IN THE OFF position ( see part STV-40 in photo)..., turn clockwise (stove should be in the off position from the factory.)
(3) Holding the tank STV-118, (shiny thing), put some pressure in TANK. Apply pressure using part #6.(you can add pressure up to 1 on the gauge (Part #149-STV)....OR.... 6 - 10 pumps is fine to start.
(4) Fill Preheat cup first with the fuel you are using.with white & blue bottle (provided). Apply Flame (match or cigarette lighter) to the fuel inside preheat cup.
(5) Allow stove to PREHEAT (using Ethanol,.Methanol, or Alcohol) for approx. 30-60 seconds . (Preheating time is determined by atmospheric/altitude conditions, and fuel.!! WARNING!! Iinsufficient preheating time, will cause raw fuel to come out of -(# 50) and make large flame.. Insufficient preheating time (when you turn the stove on), can cause a buildup of fuel in the mixing chamber (located below the screw that holds the burner assembly in place), and may look like a leak.
****YOU MAY NEED TO ADD PRESSURE, now, if you did not apply pressure before this step!!)
6) AFTER 30 to 60 seconds....(preheating).....TURN ON/OFF(STV-40) KNOB, COUNTER-CLOCKWISE (slowly), and LISTEN FOR STOVE TO START OPERATING. You MAY or MAY NOT SEE A FLAME in the burner.
(7) PRESSURIZE STOVE TO DESIRED PRESSURE (Part # 6). (Stove will build it's pressure to about 1 & 1/2 bars to 3). It will hold pressure, so it is not necessary to pump stove on continuous basis. ADJUST STOVE TO DESIRED FLAME OUTPUT- 2 ways. (SEE PHOTOS BELOW -(a) Stove equipped with brass block w/screw). (b) Turn knob.(#40- STV)
(8)TO TURN OFF STOVE - Release pressure off 149-STV by turning Part #13 counter-clockwise, and turn knob (part 40-STV) clock wise. (SEE PHOTOS BELOW)
Video demonstration Methanol Ethanol Stove
Stove Breakdown and Replacement Parts Price List
